Polycarbonate Sight Glass for 35L & 65L BrewZilla | Gen 3

The BrewZilla Polycarbonate Sight Glass comes assembled with stepless clamps and fits both the 35L and 65L units. This piece is installed in place of the stainless recirculation tube and allows you to check your fill level or watch your wort clarify during mash recirculation.

Intended for use with BrewZilla model 3.1.1 or earlier. Not compatible with the Gen 4 BrewZilla. Support brackets on older models may be too small for the 0.59" OD polycarbonate tube.

Includes:

• Stainless 1/2" Male BSP threaded post with o-rings
• Stainless 1/2" Female BSP threaded post with o-rings
• 360 mm long polycarbonate tube (13 mm ID x 15 mm OD)

Please note: you may need to use varying amounts of plumber's tape to get it to seal in the right position once it has been tightened back down on the female bottom end.

Warning: if using PBW, it is recommended to not have an extended contact time at temperatures above 120°F or exceeding the recommended dilution ratio.

KegLand Part Number: KL17114